Longhorn Services installs gas furnaces, electric furnaces, and heat pumps throughout Fort Worth, TX, and most replacements are completed in a single day. Every heater installation in Fort Worth, TX is performed under Texas HVAC license TACLA00146732E by technicians who work for owner Jesse Vasquez, who has spent more than 20 years in the Dallas-Fort Worth market.
The job starts with a load calculation, a ductwork inspection, and an honest look at the equipment you already own. If the system can still be saved, we say so, and a standard heater repair in Fort Worth runs $150 to $600 depending on the failed component. When replacement makes more sense, we remove the old unit, set the new one, test combustion, calibrate the thermostat, and register the manufacturer warranty. We install Carrier, Trane, Lennox, Goodman, Rheem, York, Daikin, American Standard, and Bryant equipment.
Heating service matters in Fort Worth, TX because North Texas winters swing hard. A 70 degree afternoon can drop below freezing overnight, and a furnace that sat idle since February is the one that fails at 2 a.m. Fast heater repair in Fort Worth, TX keeps a cold snap from turning into frozen pipes.
The safety side is bigger than comfort. Cracked heat exchangers, blocked flues, and failed rollout switches can push carbon monoxide into living space. Our technicians hold Texas HVAC license TACLA00146732E and EPA 608 certification, and they test combustion and draft on every heater maintenance visit, not just when a customer asks.
Age drives the rest of the decision. Furnaces installed 15 to 20 years ago lose efficiency every season, and repeated repairs on an aging unit rarely beat a planned heater installation. Restricted airflow makes it worse, which is why duct cleaning in Fort Worth is often the cheapest efficiency fix in the house. The same blower carries your air conditioning load, so the cooling side of the system benefits too.
Strange noises, uneven heat, or no warmth at all usually trace back to four things: ignition, airflow, controls, or a failed blower motor. Our technicians diagnose the exact cause on the first visit and quote the fix before touching a tool. Same-week heater repair in Fort Worth, TX is standard, and emergency slots stay open during cold snaps.
Ignition faults, cracked hot surface ignitors, dirty flame sensors, and failing gas valves account for most no-heat calls we take in Fort Worth. Airflow problems point somewhere else: a clogged filter, a collapsed duct run, or a return that was undersized when the house was built. That is where air duct cleaning and a full heating system tune-up pay for themselves.
When a repair no longer makes financial sense, we lay out the replacement math instead of guessing. Repairs typically run $150 to $600, so a $1,200 blower and heat exchanger job on an 18 year old furnace is usually the moment to price a new heater installation. We work on Carrier, Trane, Lennox, Goodman, Rheem, York, Daikin, American Standard, and Bryant systems, under license TACLA00146732E and 20 plus years of DFW field experience.
Our technicians size, install, and service all three under license TACLA00146732E, including Carrier, Trane, Lennox, Goodman, and Rheem equipment. We handle heater installation, heater repair, and heater maintenance in Fort Worth, plus the ductwork and cooling equipment that share the same air handler. Compare options with our instant quote tool or book an assessment.
That single visit is what stands between a working furnace and an emergency heater repair in January. Book annual heating maintenance in Fort Worth, TX, pair it with duct cleaning if airflow is weak, and schedule AC maintenance in spring. If the unit is beyond saving, we price a new furnace honestly. See current maintenance specials or book online.
Technicians arrive stocked with ignitors, flame sensors, capacitors, and blower motors, so most emergency heater repairs in Fort Worth finish on the first visit for $150 to $600. Work is performed under license TACLA00146732E and backed by a 90-day workmanship warranty. If the system is unsafe, we shut it down and quote a replacement furnace the same day. Ask about maintenance plans that prevent the next one, learn more about our DFW team, or book emergency service now. We also cover Arlington.
Annual heater maintenance in Fort Worth, TX costs far less than the breakdown it prevents. One tune-up before winter keeps efficiency high, protects the manufacturer warranty, and catches the small faults that turn into $600 heater repair bills on the coldest night of the year.
A Longhorn heater maintenance visit in Fort Worth includes a heat exchanger inspection for cracks, burner cleaning and combustion analysis, gas pressure verification, safety control testing, electrical connection tightening, blower amperage checks, and thermostat calibration. Technicians work under Texas HVAC license TACLA00146732E and carry EPA 608 certification for any refrigerant handling on heat pump systems.
Maintenance also protects the equipment you already paid for. Dirty filters and leaking ducts force the blower to work harder, which shortens motor life and drives up bills, so we frequently recommend duct cleaning alongside the tune-up. The same blower runs your air conditioner, so scheduling AC maintenance in spring keeps the whole cooling and heating system on one calendar.
A heater that will not start in Fort Worth, TX usually points to a tripped breaker, a failed ignitor, a bad control board, or a locked-out gas valve. Our technicians trace the fault, quote the part, and restore heat the same visit. Book heater repair in Fort Worth or schedule online.
When the blower runs but the air stays cold, the cause is normally a thermostat fault, a dirty flame sensor, a pilot or ignition failure, or a filter choking airflow. Longhorn Services diagnoses it under license TACLA00146732E. Get furnace repair in Fort Worth, TX or check airflow and duct cleaning.
Banging, rattling, or screeching from a furnace signals delayed ignition, a failing blower bearing, or a loose panel. Ignoring it turns a $150 part into a motor replacement. Our Fort Worth technicians locate the source, then handle the heater repair or recommend a full tune-up.
Uneven heating across a Fort Worth, TX home points to duct leaks, closed or crushed runs, a clogged filter, or an undersized system. We test static pressure before recommending anything. Fix it with duct cleaning and sealing, heater repair, or a correctly sized heater installation.
Rising winter bills with falling comfort mean your heater is running longer to do the same work. Dirty burners, leaking ducts, and a failing blower are the usual causes. An annual heater tune-up in Fort Worth restores efficiency, and current coupons help offset the cost.
Short cycling, meaning the furnace starts and stops every few minutes, usually comes from a dirty flame sensor, an overheating limit switch, or an oversized unit. Each one shortens equipment life. Our Fort Worth, TX technicians correct it with professional heater repair or, when sizing is the problem, a proper system replacement.
Longhorn Services is a Fort Worth heating contractor, not a franchise. Owner Jesse Vasquez has worked HVAC systems across Dallas-Fort Worth for more than 20 years, and the company holds Texas HVAC license TACLA00146732E and refrigeration license TACLB00146732R.
What that means on a service call: honest diagnostics, a written price before work starts, and a 90-day workmanship warranty on every heater repair in Fort Worth, TX. Our technicians are EPA 608 certified and service Carrier, Trane, Lennox, Goodman, Rheem, York, Daikin, American Standard, and Bryant equipment, whether the job is a furnace replacement or a seasonal heating tune-up.
Heater repair in Fort Worth, TX typically costs $150 to $600, parts and labor included. The diagnostic fee is applied to the repair when you approve the work, and you see the price before we start. Estimate yours with the instant quote tool or review current coupons.
We book same-week appointments for standard heater repair in Fort Worth and hold emergency slots open during freeze events. Trucks run six days a week across Fort Worth and the wider DFW service area. Book a technician online or call 469-824-3555.
Our trucks carry hot surface ignitors, flame sensors, capacitors, limit switches, gas valves, and blower motors for Carrier, Trane, Lennox, Goodman, Rheem, York, Daikin, American Standard, and Bryant systems. Most Fort Worth furnace repairs finish on the first visit, without a second trip for parts or replacement.
Comfort problems that survive a repair are almost always duct problems. We measure static pressure, check return sizing, and seal or clean the runs that are starving your rooms. Ask about air duct cleaning in Fort Worth, which improves both heating and air conditioning performance.
Before we leave, technicians run a combustion analysis, verify temperature rise, and confirm the thermostat matches actual room temperature. That is how a heating tune-up in Fort Worth, TX turns into a lower gas bill instead of a service ticket. Pair it with spring AC maintenance.
Every heater repair carries a 90-day workmanship warranty, and manufacturer parts warranties are registered on installs. Longhorn Services holds Texas HVAC license TACLA00146732E and refrigeration license TACLB00146732R. Read more about Jesse Vasquez and our DFW crew, or schedule service.
Longhorn Services provides heater repair, heater installation, and heater maintenance in Fort Worth, TX. We service gas furnaces, electric furnaces, and heat pumps for homes and commercial buildings, and we handle thermostat replacement, ignition faults, and airflow problems on the same visit.
Most heater repairs in Fort Worth, TX run $150 to $600, parts and labor included. Simple ignitor or flame sensor replacements sit at the low end, while blower motors and gas valves reach the high end. You approve a written price before work begins. Check current coupons before booking.
Yes. We provide 24/7 emergency heater repair in Fort Worth, TX, with priority response during freeze events. Technicians arrive stocked with ignitors, sensors, capacitors, and blower motors, so most no-heat calls are resolved on the first visit.
Once a year, before the first cold snap. An annual heating tune-up in Fort Worth includes a heat exchanger inspection, burner cleaning, combustion analysis, and safety control testing. It prevents most winter breakdowns and keeps your manufacturer warranty valid.
Consider replacement when the furnace passes 15 to 20 years, needs repeated repairs, or a single repair approaches half the cost of a new system. Our technicians give you the repair-versus-replace math in writing. Compare options with heater installation in Fort Worth, TX.
Yes. Longhorn Services holds Texas HVAC license TACLA00146732E and refrigeration license TACLB00146732R, and our technicians are EPA 608 certified for refrigerant handling. Owner Jesse Vasquez has worked DFW heating and cooling systems for over 20 years.
We repair and install Carrier, Trane, Lennox, Goodman, Rheem, York, Daikin, American Standard, and Bryant heating equipment across Fort Worth and the wider DFW metroplex. Our trucks stock common parts for these brands, which keeps most repairs to a single visit.
Book online at schedule.booklonghorn.com or call 469-824-3555. You can also price the job first with our instant quote tool. Installation estimates are free, and same-week heater repair appointments in Fort Worth are available six days a week.
If you are planning a major refrigeration repair or equipment upgrade in Dallas-Fort Worth, TX, navigating local codes and health regulations is vital to protect your inventory. These regional resources govern food safety and equipment standards across the Metroplex. For immediate pricing estimates or to schedule a repair, contact Longhorn Services directly at 469-824-3555.
Dallas County Environmental Health
2377 N Stemmons Fwy, Fort Worth, TX 75207
For businesses operating in the eastern half of the Metroplex, this department enforces strict food safety standards and commercial kitchen codes. When critical equipment like walk-in coolers, walk-in freezers, or ice machines break down, prompt commercial repair is required to prevent inventory loss. We help local restaurants maintain their health inspection compliance with our fast emergency service.
Tarrant County Public Health — Environmental Health
1101 S Main St, Fort Worth, TX 76104
Serving the western side of the Metroplex, this office regulates commercial kitchens and food handling safety for Fort Worth, Arlington, and surrounding cities. If your facility experiences a sudden commercial freezer failure or an issue with a prep table cooler, rapid refrigeration service prevents costly health code violations. Trust our certified technicians to restore your cooling systems reliably.
Texas Department of Licensing and Regulation (TDLR) — Dallas Region
6330 Highway 290 East, Austin, TX 78723 (main office) | Verify licenses online at tdlr.texas.gov
(800) 682-1718
TDLR issues and regulates HVAC, refrigeration, and appliance contractor licenses in Texas. You can verify that any company you hire holds a valid license before they enter your home. Longhorn Services carries HVAC License TACLA00146732E and Refrigeration License TACLB00146732R, both verifiable through TDLR. This applies to AC repair, commercial refrigeration, and appliance repair contractors working in Dallas, TX.